Furnace & air handler control board, compatible replacement for Nordyne 1006801R
Furnace · Compatible replacement

Compatible Control Board for Nordyne 1006801R

Replaces Nordyne 1006801R
Replaces
1006801R10068001006801
Fits
Nordyne, Intertherm, Miller, Gibson and Frigidaire E7-series electric furnaces (E7EB, E7ED, E7EM, E7EU) and FSHE air handlers, single-stage
In the box
Control board with ECM blower header and status display
Type
Aftermarket compatible board
$79.00USD

Signs your 1006801R board has failed

  • Blower won't start, or runs nonstop and won't shut off
  • Heat strips never come on when the thermostat calls for heat
  • No 24 volt power at the thermostat terminals
  • Burn marks or a melted connector on the old board

Before you install

  1. Read the part number on your old board and find it in the Replaces list
  2. Check the transformer and fuse; a shorted thermostat wire can blow a new board
  3. Check the blower motor and heat-strip limits before installing
  4. Photograph every connector and wire position before you unplug anything
  5. Turn off power at the breaker before you start

Questions

Is this an original Nordyne part?

No. It is an aftermarket board built to replace the original 1006801R. BoardFits is not affiliated with Nordyne or Nortek.

My old board says 1006800. Will this work?

Yes. 1006800 and 1006801 are older numbers for the same board, and they are covered by this replacement.

Does it work on two-stage systems?

This board is for single-stage EHEAT and FSHE setups. If your unit is two-stage, send us the model number before ordering.